Brake and turn signal separator module
Defect Summary
Collins is recalling certain model year 2009 bantam, super bantam, and grand bantam school buses manufactured between april 1 and october 1, 2009, built on ford cutaway chassis. the brake-turn separator module which is used to control the brake lights and turn signals lights in the rear may not always distinguish correctly between a brake signal input and a turn signal input from the ford chassis oem wiring. for typical brake and turn signal operation, the stop/tail/turn lights at the rear of the bus will function properly. however, if the brakes are pumped/applied in a frequency matching that of the blinking turn signal while the turn indicator is on, there is the potential that the brake signal through the module may cancel out the turn signal temporarily or cause it to flash intermittently.
Safety Consequence
This can cause confusion to vehicles behind the bus as to whether the bus is turning or stopping increasing the risk of a crash.
Corrective Action
Collins will notify owners and dealers will replace the brake-turn signal separator module, if the bus is equipped with one, free of charge. the safety recall began on march 2, 2010. owners may contact collins toll-free at 1-800-533-1850 ext. 424.
Similar Recalls
Other recalls from Collins Bus Corporation or involving Exterior Lighting.
FAQ: Recall 10V049000
Your rights, the repair process, and what each field on this page means.
What is recall 10V049000?
NHTSA recall 10V049000 was issued by Collins Bus Corporation on February 18, 2010. It addresses: Brake and turn signal separator module. The recall affects approximately 112 vehicles, with the defect involving the Exterior Lighting component.
How do I get this recall repaired?
Contact any authorized Collins Bus Corporation dealer and reference NHTSA recall ID 10V049000 or the manufacturer campaign number NR (Not Reported). Under federal law, the repair is completely free regardless of vehicle age or owner history.
Is my vehicle included in this recall?
The only way to confirm is to look up your 17-character VIN at nhtsa.gov/recalls. NHTSA's tool will tell you if VIN-by-VIN this exact recall applies.
How long do I have to get a recall repair done?
There is no expiration on most federal safety recalls. Even if your vehicle is years old and you bought it used, the manufacturer is required to perform the repair at no cost.
Where does the data on this page come from?
All information on this page is sourced directly from the U.S. Department of Transportation public dataset for NHTSA recalls. Last refreshed: 2026-05-22. For the most current official notice, visit nhtsa.gov/recalls.