Suspension:independent front control arm:unknown t
Defect Summary
Ball joints may contain a 35/64 inch thick castellated nut instead of the correct 23/32 inch thick nut. Due to the incorrect size, the nut may loosen until it comes into contact with the cotter pin. Corresponding loosening of the tapered ball stud could lead to fracture of the ball joint stud. This would result in separation of the ball joint to steering knuckle connection and collapse of the lower part of the wheel assembly.
Corrective Action
Upon inspection, dealer will install the proper nut in the ball joint assembly without charge to owner.
Similar Recalls
Other recalls from Dana Corporation or involving Suspension.
FAQ: Recall 80E023000
Your rights, the repair process, and what each field on this page means.
What is recall 80E023000?
NHTSA recall 80E023000 was issued by Dana Corporation on September 24, 1980. It addresses: Suspension:independent front control arm:unknown t. The recall affects approximately 35,411 vehicles, with the defect involving the Suspension component.
How do I get this recall repaired?
Contact any authorized Dana Corporation dealer and reference NHTSA recall ID 80E023000 or the manufacturer campaign number NR (Not Reported). Under federal law, the repair is completely free regardless of vehicle age or owner history.
Is my vehicle included in this recall?
The only way to confirm is to look up your 17-character VIN at nhtsa.gov/recalls. NHTSA's tool will tell you if VIN-by-VIN this exact recall applies.
How long do I have to get a recall repair done?
There is no expiration on most federal safety recalls. Even if your vehicle is years old and you bought it used, the manufacturer is required to perform the repair at no cost.
Where does the data on this page come from?
All information on this page is sourced directly from the U.S. Department of Transportation public dataset for NHTSA recalls. Last refreshed: 2026-05-22. For the most current official notice, visit nhtsa.gov/recalls.