Suspension:single axle:rear
Defect Summary
The bolts that clamp the mor/ryde suspension beam and lower mounting plate to the axle may break as a result of misalignment of the bolts due to non-parallel surfaces of the upper beam plate and the lower bottom plate. Another contributing factor is the absence of shear blocks to the upper spacer pad.
Corrective Action
Manufacturer will install new mor/ryde beam assemblies, lower mounting plates, bolts, nuts and washers.
Similar Recalls
Other recalls from Hendrickson Mfg. Co. or involving Suspension.
FAQ: Recall 80V069000
Your rights, the repair process, and what each field on this page means.
What is recall 80V069000?
NHTSA recall 80V069000 was issued by Hendrickson Mfg. Co. on May 28, 1980. It addresses: Suspension:single axle:rear. The recall affects approximately 75 vehicles, with the defect involving the Suspension component.
How do I get this recall repaired?
Contact any authorized Hendrickson Mfg. Co. dealer and reference NHTSA recall ID 80V069000 or the manufacturer campaign number NR (Not Reported). Under federal law, the repair is completely free regardless of vehicle age or owner history.
Is my vehicle included in this recall?
The only way to confirm is to look up your 17-character VIN at nhtsa.gov/recalls. NHTSA's tool will tell you if VIN-by-VIN this exact recall applies.
How long do I have to get a recall repair done?
There is no expiration on most federal safety recalls. Even if your vehicle is years old and you bought it used, the manufacturer is required to perform the repair at no cost.
Where does the data on this page come from?
All information on this page is sourced directly from the U.S. Department of Transportation public dataset for NHTSA recalls. Last refreshed: 2026-05-22. For the most current official notice, visit nhtsa.gov/recalls.