Suspension:single axle:rear
Defect Summary
The axle housings were manufactured with a tight friction weld curl radius on the inside diameter of the axle housing. Under operational loads, cracks can initiate at the weld curl radius on the inside of the housing. These cracks may propagate, eventually allowing the axle spindle to separate from the axle housing.
Corrective Action
Replace the axle housing with a new axle housing.
Similar Recalls
Other recalls from International Truck & Engine Corporation or involving Suspension.
FAQ: Recall 91E047000
Your rights, the repair process, and what each field on this page means.
What is recall 91E047000?
NHTSA recall 91E047000 was issued by International Truck & Engine Corporation on December 31, 1991. It addresses: Suspension:single axle:rear. The recall affects approximately 916 vehicles, with the defect involving the Suspension component.
How do I get this recall repaired?
Contact any authorized International Truck & Engine Corporation dealer and reference NHTSA recall ID 91E047000 or the manufacturer campaign number NR (Not Reported). Under federal law, the repair is completely free regardless of vehicle age or owner history.
Is my vehicle included in this recall?
The only way to confirm is to look up your 17-character VIN at nhtsa.gov/recalls. NHTSA's tool will tell you if VIN-by-VIN this exact recall applies.
How long do I have to get a recall repair done?
There is no expiration on most federal safety recalls. Even if your vehicle is years old and you bought it used, the manufacturer is required to perform the repair at no cost.
Where does the data on this page come from?
All information on this page is sourced directly from the U.S. Department of Transportation public dataset for NHTSA recalls. Last refreshed: 2026-05-22. For the most current official notice, visit nhtsa.gov/recalls.