Steering:gear:rack and pinion
Defect Summary
Two of the four bolt-and-washer combinations used to secure the 710 saginaw steering gear to the chassis frame had different washer material thicknesses. This can affect the bolt thread engagement into the steering gear causing loose steering gear bolts.
Safety Consequence
This condition can cause loss of steering control increasing the potential for a vehicle accident.
Corrective Action
Dealers will increase the steering gear bolt hole depth, replace the existing washers and bolts with new flanged-head cap screws installed with loctite.
Similar Recalls
Other recalls from Oshkosh Corporation or involving Steering.
FAQ: Recall 95V022000
Your rights, the repair process, and what each field on this page means.
What is recall 95V022000?
NHTSA recall 95V022000 was issued by Oshkosh Corporation on February 7, 1995. It addresses: Steering:gear:rack and pinion. The recall affects approximately 336 vehicles, with the defect involving the Steering component.
How do I get this recall repaired?
Contact any authorized Oshkosh Corporation dealer and reference NHTSA recall ID 95V022000 or the manufacturer campaign number NR (Not Reported). Under federal law, the repair is completely free regardless of vehicle age or owner history.
Is my vehicle included in this recall?
The only way to confirm is to look up your 17-character VIN at nhtsa.gov/recalls. NHTSA's tool will tell you if VIN-by-VIN this exact recall applies.
How long do I have to get a recall repair done?
There is no expiration on most federal safety recalls. Even if your vehicle is years old and you bought it used, the manufacturer is required to perform the repair at no cost.
Where does the data on this page come from?
All information on this page is sourced directly from the U.S. Department of Transportation public dataset for NHTSA recalls. Last refreshed: 2026-05-22. For the most current official notice, visit nhtsa.gov/recalls.